45043 Exposure Head Interface EHI: thermal head humidity alarm, <Humidity> percent Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 Every thirty seconds, the thermal head firmware reads the humidity sensor and compares the reading to the threshhold configured by the head NVS parameter humidity. If the threshhold has been exceeded, the thermal head is shutdown and any plot in progress is aborted. Setting the head NVS parameter humidity to zero disables the humidity check. The humidity sensor is only available on some heads. Issue the command "head version" and note the line "PHC hardware version". If the "PHC hardware version" >= 3, the thermal head has a humidity sensor. This error code applies to Thermal Head firmware version 1.30 and above. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Verify the humidity of the environment local to the machine. Humidity The humidity that triggered this humidity alarm. 03-Jul-2002 ../prm/ehi_head_humidity.xmlPRM: head humidity ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:44 2008 PST